background image

RS Stock number 

877-1791 

RS, Professionally Approved Products, gives you professional quality parts across all products categories. Our range has 
been testified by engineers as giving comparable quality to that of the leading brands without paying a premium price. 

Protection: IP 54 Splash Proof  
DIN 863/1 
Clear LCD Display 
Metric/Inch Conversion 
Relative & Absolute Modes 
Resolution 0.001mm/0.0005” 
Tungsten Carbide Anvils 
Ratchet Stop 
Spindle Lock 
Setting Rods 
Supplied in fitted case 

Packed Weight and Dimensions 

RS Code 

Description 

Weight g 

W mm 

H mm 

L mm 

8771791 

Electronic Micrometer 0-150mm / 0 -6” 

1960 

265 

45 

425 

 

RS Code 

Range 
mm/1nch 

mm 

mm 

Accuracy 

mm 

8771791 

0-150 

82 

158 

0.003 

Power:      1 x SR44: 1.5V battery 

 

              

 

 
2   Locking Device 
3   Thimble 
4   Ratchet Stop 
5   ON/OFF & SET Button 
6   ABS/INC & UNIT Button 
7   Data Output button (not available) 
8   Battery cover 

 

RS, Professionally Approved Products, gives you professional quality parts across all products categories. Our range has
been testified by engineers as giving comparable quality to that of the leading brands without paying a premium price

.

ENGLISH

Summary of Contents for 877-1791

Page 1: ...etting Rods Supplied in fitted case Packed Weight and Dimensions RS Code Description Weight g W mm H mm L mm 8771791 Electronic Micrometer 0 150mm 0 6 1960 265 45 425 RS Code Range mm 1nch A mm L mm Accuracy mm 8771791 0 150 82 158 0 003 Power 1 x SR44 1 5V battery 2 Locking Device 3 Thimble 4 Ratchet Stop 5 ON OFF SET Button 6 ABS INC UNIT Button 7 Data Output button not available 8 Battery cover...

Page 2: ...t until required number is displayed 7 Press and hold SET button to advance to the next digit 8 Repeat actions 6 7 until all the digits on the display have been programmed 9 Once the last digit has been programmed press and hold the SET button until Set flashes in the display 10 Press and release SET button to cancel the flashing Set on the display 11 The micrometer is now set and ready for use Bu...

Page 3: ...s not to be used for a long period of time Do not disassemble or drop the instrument Do not mark the instrument by engraving etching or any other permanent method of marking as this will invalidate the warranty Fault Finding Failure Causes Remedy Display E 1 Display Exxxxx Measured value is over display range Reset the origin or change to relative mode Display E 2 The origin is too great Reset the...

Page 4: ...ge block to check the zero position If the zero point does not line up as required it can be corrected by using the following procedure When the zero point deviation on the thimble is under 2 divisions from the graduated base line Turn the sleeve using the C spanner provided until correct alignment is achieved When the zero point deviation on the thimble is over 2 divisions from the graduated base...

Reviews: