Preparation for use
Installation of dehumidifier air filter.
1. Remove the back cover.
Use the indents to lift away cover
2. Remove the filter holder from the back cover.
Filter holder is clipped to the inside of the cover.
The filter holder then unclips and is ready for the filter
3. Installing/changing filter.
Remove the filter out of its packaging and put in
the filter holder. Repeat in reverse step 2, placing
the filter holder on the clips of the back cover with the flat surface
facing up, and set the holder to the four catches in the
cover (with the convex portions of the holder upward).
Replace the cover securely, pressing its perimeter making sure
It is flush
●
In case of incorrect alignment of the filter, the cover cannot be correctly replaced.
____________________________________________________________________________
Replacing the cover.
To ease installation, install
one side of the cover first, and
then the other.
____________________________________________________________________________
Water tank orientation.
NB.
The dehumidifier will not operate if the water tank
Is full of water or it is not located correctly.
How to remove
Draw the water tank gently toward you by holding the
Concave sides of the tank.
How to install
Push the tank horizontally and gently. The
handle folds down flat within the take.
Take care, not to damage to level float in either operation
-
10
-
