Installation and Operation Manual
MAN332%1.pm5
page 2
Important Safety Instructions
•
WHEN REPLACING BATTERIES, USE THE SAME QUANTITY AND TYPE OF BATTERIES:
SEALED LEAD-ACID MAINTENANCE FREE:
PTM280VA: 1 x 7AH/12V
PTM420VA: 1 x 7AH/12V
PTM650VA: 1 x 11AH/12V
PTM1KVA: 3 x 11AH/6V
•
PROPER DISPOSAL OF BATTERIES IS REQUIRED. PLEASE REFER TO YOUR LOCAL CODES
FOR DISPOSAL REQUIREMENTS.
•
THE UPS CONTAINS VOLTAGES WHICH ARE POTENTIALLY HAZARDOUS. ALL REPAIRS
SHOULD BE PERFORMED BY QUALIFIED SERVICE PERSONNEL.
•
THE UPS HAS ITS OWN INTERNAL ENERGY SOURCE (BATTERY). THE OUTPUT
RECEPTACLES MAY BE LIVE EVEN WHEN THE UPS IS NOT CONNECTED TO AN AC
SUPPLY.
For safe and continuous operation of the UPS depends partially on the care taken by users. Please observe
the following precautions.
•
Do not disassemble the UPS.
•
Do not attempt to power the UPS from any supply, other than a 3-wire grounded source.
•
Do not place the UPS near water or in environments of excessive humidity.
•
Do not block the air vents on the side of the UPS.
•
Do not plug appliances, such as hair dryers, into the UPS sockets.
•
Do not place the UPS under direct sunshine or close to heat-emitting sources.
•
This UPS is intended for installation in a temperature controlled, indoor area free of conductive
contaminants.
