6—Using the S-1608/S-0816 System
S-1608/S-0816 Digital Snake Owner’s Manual
43
S-1608/S-0816 Audio Connections
fig.6-24.eps
The S-1608’s (S-0816’s) balanced audio I/O is provided on XLR-type jacks. The wiring diagram for
these jacks is shown in the following illustration. Make connections after first checking the wiring
diagrams of other equipment you intend to connect.
fig.6-25.eps
Audio Connections
When making audio input connections with the S-1608 and/or S-0816 units powered on, always press
and hold the [MUTE ALL OUTPUTS] button on the respective unit’s front panel so its indicator lights.
This will mute the sound coming from the S-1608/S-0816 System’s audio outputs and prevent
possible damage to connected speakers and other devices. See Page 48 for more information about
[MUTE ALL OUTPUTS].
Note that [MUTE ALL OUTPUTS] only mutes the outputs of the S-1608/S-0816 System, and not the
outputs of other devices. Before connecting the audio outputs on the S-1608 and S-0816 units to the
audio inputs of other devices, always turn down the volume or turn off the power on the receiving
devices to prevent possible damage.
To prevent hazard or damage, ensure that only microphone cables and microphones conforming to
IEC-268-15A are connected.
Afin d’éviter tout risque ou dommage, ne brancher que des câbles de
microphone et des microphones conformes à la norme IEC-268-15A.
16 XLR inputs
(connect mics,
instruments,
etc.)
8 XLR outputs
(connect to
amplifiers, mixing
consoles, etc.)
GROUND
HOT
COLD
1
3
2
S-1608_e.book 43 ページ ２００７年１１月８日 木曜日 午後１２時１分
