6—Using the S-1608/S-0816 System
46
S-1608/S-0816 Digital Snake Owner’s Manual
Powering Up
Connect and power up devices in the following order:
1.
Connect the S-1608/S-0816 system components as described previously.
2.
Connect audio devices to the S-1608 and S-0816 inputs and outputs as described previously.
3.
Turn on any devices connected to the S-1608 and S-0816 units’ audio inputs.
4.
Turn on the power of the S-1608 and S-0816 units.
Use the included AC power cord to connect between an AC outlet and the AC IN connector on
the side panel. Power is supplied to the S-1608/S-0816, and the POWER indicator lights up.
5.
Turn on the power to the audio devices (mixing consoles, power amplifiers, monitor speakers,
etc.) connected to the S-1608 and S-0816 units’ audio outputs. (Note: It’s always best to power
on any speakers or amplification systems last.)
Powering Off
Perform the following steps to power off the S-1608/S-0816 System.
1.
Turn down the volume and power off any devices connected to the S-1608 and S-0816 units’
inputs and outputs. (Note: It’s always best to turn down the volume and power off any speakers
or amplification systems first.)
2.
If an S-4000R is connected to the system, press and hold the S-4000R’s [LOCK] button until its
indicator lights. (Locking the S-4000R retains the current S-1608 and S-0816 input settings when
the power is turned off.)
3.
To power off the S-1608 and S-0816 units, unplug the power cords from the AC outlets.
Powering Up
Turn on power to your various devices in the order specified. By turning on devices in the wrong
order, you risk causing malfunction and/or damage to speakers and other devices.
Additionally, in each of the following steps, allow each piece of equipment to finish its power-up
sequence before proceeding to the next step.
The S-1608 and S-0816 units are equipped with protection circuits. A brief interval (a few seconds)
after power up is required before the units will operate normally.
S-1608_e.book 46 ページ ２００７年１１月８日 木曜日 午後１２時１分
