14
System Connection Example
* The S-1608 system must be running system software version 2.0 or later.
If you’re using the S-4000 system, the S-4000 system must be running system software 2.1 or later.
* In order to maintain the transmission quality of the digital REAC signal, use fully approved Cat5e Ethernet cable such as the 20 meter or 100 meter
REAC cables (SC-W20F/SC-W100S/W100S-R; sold separately).
Connecting the S-4000D to an Analog Mixer System
S-4000D
S-1608 (
Master REAC device)
Computer
Analog/Digital Mixer
REAC port 1 or 2
M-48 x 8
Keyboard
Guitar
Bass
Lead Vocal
Drum
Serial port
Vocal 1
Vocal 2
Vocal 3
4
5
6
7
8
9
10
REMOTE
connector
RS-232C cable
REAC port
INPUT connector 1–16
REAC cable or Cat5e Ethernet cable
REAC port 3
REAC cable or Cat5e Ethernet cable
* You’ll need to install the S-4000 RCS
version 2.0 (or later) S-4000 remote
control software.
* You can connect up to 16 bus out or channel
direct out signals.
If the S-1608 is replaced by the S-4000S, a
total of 40 signals can be connected.
S-4000D_e.book 14 ページ ２００９年５月２５日 月曜日 午前１１時４６分
