In normal mode, Holding “CLOCK SET” for 3 seconds to enter time setting.
Hour display is flashing, Press “+”, “-“ to set the value. Press “CLOCK SET” to confirm.
Minutes display is flashing, Press “+”, “-“ to set the value. Press “CLOCK SET” to confirm..
RCC ON/OFF display is flashing, Press “+”, “-“ to set. Press “CLOCK SET” to confirm..
Time Zone display is flashing, Press “+”, “-“ to set. Press “CLOCK SET” to confirm.
DST ON/OFF display is flashing, Press “+”, “-“ to set. Press “CLOCK SET” to confirm.
Information:
Without any press in 20 seconds, it will exit setting automatically.
When RCC setting is OFF, no automatical reception for RCC.
When DST setting is ON, no matter receive the RCC or not, it will adjust the DST automati-
cally.
When Zone setting is ON, it will adjust the time automatically after RCC reception with Z
symbol display.
When the battery of main unit and sensor are low,
symbol will display.
RST02717 5
Operation procedures
Time Setting
Low Battery
02717-Manual-NEW:02717-Manual 01.03.2011 15:37 Page 5
