Real Time Automation, Inc.
43
1-800-249-1612
String Mapping
– Explanation
Below are the different parts that can be modified to make up a string mapping.
String data types can only be mapped to other string data types. There is no manipulation that can be
done on the string.
1)
Enable
(red box above):
Check to enable mapping. If not checked, this mapping is skipped.
2)
Source Field
(yellow box above):
a)
Group - Select the string data group you set up in the protocol config to use for this mapping.
b)
String - This is the string used for this mapping.
3)
Destination Field
(green box above)
:
a)
Group - Select the string data group you set up in the protocol config to use for this mapping.
b)
String - This is the string where the data is being stored.
