Real Time Automation, Inc.
10
1-800-249-1612
Port Configuration
The Port Configuration page is where you set port specific parameters. These settings must match the
settings of the device(s) that you are connecting to.
NOTE
: Either port can be used for RS-232 communications but only one physical port can be used at a
time.
When you have completed your port configuration, click the
Save Parameters
button.
The default jumper configurations are setup for the following serial modes:
Port 0
–
RS232
Port 1
–
RS232
If you require a different serial mode, please refer to the
N34_Hardware_Jumper_Configuration.pdf on the CD to make jumper changes.