RTD Embedded Technologies, Inc.
|
www.rtd.com
11
LAN24550/
LAN34550 User’s Manual
Steps for Installing
1.
Always work at an ESD protected workstation, and wear a grounded wrist-strap.
2.
Turn off power to the PC/104 system or stack.
3.
Select and install stand-offs to properly position the module on the stack.
4.
Remove the module from its anti-static bag.
5.
Check that pins of the bus connector are properly positioned.
6.
Check the stacking order; make sure all of the busses used by the peripheral cards are connected to the cpuModule.
7.
Hold the module by its edges and orient it so the bus connector pins line up with the matching connector on the stack.
8.
Gently and evenly press the module onto the PC/104 stack.
9.
If any boards are to be stacked above this module, install them.
10.
Attach any necessary cables to the PC/104 stack.
11.
Re-connect the power cord and apply power to the stack.
12.
Boot the system and verify that all of the hardware is working properly.
Figure 3
: Example 104™Stack