RTI RKM-1, Installation And Operation Manual

Multi-Room Audio Keypad

RKM-1

6

PROGRAMMInG
display

The RKM-1 has a flexible, programmable interface. Once the display 

lens film has been chosen and installed contains the audio sources that 

will be controlled, the display backlights are enabled/disabled within the 

Integration Designer™ software to match the sources that will be used. 

Using the available software drivers from RTI, the RKM- can communicate 

bidirectionally with many popular multi-zone receivers providing feedback 

of power status, selected source, and volume level (when used together 

with two-way enabled RTI control processors).
 
Function buttons
The function buttons can be programmed using Integration Designer™ to 

control each music source discretely. In the most basic configuration, the 

buttons can be used to execute a single function or if needed they can be 

programmed to execute complex multi-step macros.  When the RKM- is 

used with a control processor, it is capable of control via IR or RS-22.

OPeRAtIOn
Music source selection
Click the Select Music button to scroll through the sources that have been 

enabled in Integration Designer™. Once the source has been selected, the 

backlight will flash for two seconds and a command or macro will be sent 

to turn on the selected music source or. The display backlight will be lit for 

the source that is active. 

On/Off buttons
- The On button will send a command or macro to turn on the last music 

source that was selected prior to turning it off. 
- The Off button will send a command or macro to turn off the music 

for this zone and Off will be lit on the display. When Off is selected, no 

commands can be sent from the function buttons.

CleAnInG
Occasional cleaning may be required, depending on use. 
To clean your RKM-, lightly dampen a lint-free cloth with a glass cleaner 

or mild detergent, and wipe the buttons, surrounding bezel, and faceplate. 

CHAPteR 3  |  InstAllAtIOn And OPeRAtIOn