Introduction
7
GETTING STARTED
Start by inserting the battery connector into the mating plug on
the
T2-C
. Make sure the connector is oriented properly before
attempting to insert it. Next, turn the unit on by sliding the power
switch into the “ON” position (toward the battery).
After power is applied, the
T2-C
will take approximately ten
seconds to load the operating system, the application software,
and the user program. This long delay only occurs from a power-
down state. During normal use the
T2-C
turns-on instantly from
its sleep mode.
The
T2-C
is turned-on by touching any area of the display or any
keypad button. If the tilt sensor is enabled, picking up the unit
will also turn it on.
Power
Switch
