19
8. DC input mains power to the enclosure and mains power must be filtered by a DC mains
filters with attenuation characteristics of Corcom 6EH1 series filters or with similar filters with
equal or greater attenuation characteristics.
9. Insulation strip length of 0.26 inches (6.5 mm) is required on all field wirings to the I/O card
termination modules.
10. The disposal of any electronic products must be in accordance with local regulations (e.g.
Directive 2002/96/EC of the European Parliament and of the Council on waste electrical and
electronic equipment). Some RTP Corporation products contain materials that may be
detrimental to the environment. These materials may include, but are not limited to lead (in
solder) and lithium (in batteries).
11. Prior to storage or shipping, the equipment must be packaged in accordance with the
following guidelines:
● Inventory all items and inspect all components for damage.
● Verify that all fasteners are properly tightened and that the chassis I/O module retaining
bar is properly installed.
● Wrap the chassis assembly in plastic bubble wrap.
● Select a suitable shipping box that provides at least 1½ inches of space between the
equipment and all sides of the box. This space shall be tightly packed with packing
peanuts or bubble wrap to protect the equipment during storage or shipping.
● Close and secure the box with suitable packing tape.
● Do not stack boxes more than three high. Store the boxes in a protected, dry
environment. Do not expose the boxes to rain or environmental conditions beyond the
ranges specified for the equipment in this document.
