Проверил: Р.Ч./24.03.2015г
Remove any adjusting key or wrench before turning the power tool on. A wrench or a
key left attached to a rotating part of the power tool may result in personal injury.
WARNING
Before any maintenance or control, ensure machine is off position and plug is pulled
from electricity.
Installing and removing the Diamond-cutting disc.
(Fig1&Fig2)
1. Mount the inner flange onto the spindle, then fit the diamond cutting disc and clamping
flange on the spindle, tighten the clamping screw using the socket wrench, the assembly of
the clamping screw must thereby hold the clamping flange tightly with the open wrench.
2.
When mounting, make sure
that the direction of the arrows on the protective guard and
the diamond cutting disc
both point in the same direction.
3. To remove the disc, follow the installation procedure in reverse
Adjusting the Depth of cutting(Fig3)
To adjust cutting depth, loosen the winged
screw and displace the base plate along its rear side, lowering or raising it until reaching the
desired measure. Use a rule, scale or something similar to adjust the required. Retighten the
winged screw.
