RTRMAX RTM720, Manual

4.

PRESSURE METER 

5.

HOLD HANDLE 

6.

REGULATOR VALF 

7.

DISCHARGE VALF

 
SAFETY INSTRUCTIONS 

Read all instructions, failure to follow all instructions listed below may result in electric 
shock, fire and/or serious injury.  



Compressor air from the unit may contain carbon monoxide.Air 

produced is not suitable for breathing purposes. 



Always use a repirator when spraying paint or chemicals. 



Always wear safety glasses or googles when spraying air. 



Before using check the belt tightness so that when pressure is applied at 

the center, there is ½’’ slack.If the belt is installed too tightly, overloading of the 
motor will ocur. This will cause the motor overheating. If the belt is installed too 
looselely; it will slip and vibration will ocur 



Check if the quantity and quality of oil is correct. 



Check if the oil breather is clean. 



Never use the compressor without connection to a properly grounded 

outlet with the specified voltage and fuse protection. Don’t use the compressor in a 
wet or explosive enviroment. Never attempt maintenance or adjustment with power 
connected or the equipment in operation. 



Tank safety valve is factory installed to prevent the air receiver from 

damage. Adjustment by user will automatically void warranty. 



The air pressure switch is set at the factory for optimum performance of 

your particular model. Never bypass or remove this switch. Serious damage to 
equipment or personal injury could result from too high pressure. 



Air compressor gets hot while in operation. Never touch the motor, 

dischange tubing, or compressor pump while in operation. The compressor operates 
automatically while the power is on. Never operate the compressor with the belt 
guard removed. 



Avoid running the engine indoors. The exhaust gases contain harmful 

carbon monoxide 



Before using the tool, check the tool if there is worn, loosen and 

damage parts.  



Eliminate all sources of sparks or flame(smoking, open flames or work 

that can cause sparks) in areas where fuel is mixed, poured or stored. 



Do not smoke while handling fuel or while operating the chain saw.  



Use the air compressor, accessories and tool bits etc. in accordance with 

these instructions and in the manner intended for the particular type of power tool, 
taking into acccount the work conditions and the work to be performed. Use of the 
air compressor for operations different from intended could result in a hazardous 
situation. 



When air compressor is given to other people, this instruction manual 

must be given with air compressor.