13 — English
ASSEMBLY
INSTALLING THE SLIDING TABLE
See Figures 9 - 10.
To unlock the sliding table:
From the right side of the table, pull the table lock lever
out and turn the lever toward the back of the saw.
To install the sliding table:
Grasp the table firmly and set the rollers on the left side
of the sliding table on the rails first then place the rollers
on the right side of the frame.
Holding the table parallel with the frame, push the table
toward the back of the saw.
When the table lock lever reaches the stop on the front
rail on the right hand side of the frame, pull the lever out
and hold it out until the lock has passed the stop. Release
the lever.
Slide the table along the rails until the final rollers engage
the rails.
To lock the sliding table:
Turn the table lock lever until the lever points “up”.
Release the lever.
NOTE:
When the table is installed on the water tray frame
and you push the table, it will “click” into place. This is the
table lock lever snapping into a hole in the frame locking
the table in place.
WATER
TRAY
WATER TRAY
FRAME
Fig. 8
Fig. 9
Fig. 10
SAW
FRONT
TABLE LOCK
LEVER
Fig. 7
SPACER
HEX NUT
SOCKET HEAD
SCREW
UNLOCK
LOCK
ROLLERS
SLIDING
TABLE
Summary of Contents for DT180EVO
Page 71: ...25 NOTES NOTAS ...
