Page 4
STEP 4 (See Diagram 4)
1 ) Lift the wobble-free assembly onto
the mounted hook.
2 ) Install the 1st hex-head screw
together with the fixings.
3 ) Tighten up the 2nd hex-head screw
with the fixing.
4 ) Tighten the 2 screws in the middle of
wobble-free assembly.
Note:-
1. Remember to lock the pin after
tightening hex-head screws.
2. Hook must be installed on concrete
ceiling.
DIAGRAM 4
WARNING:
Installation without proper procedures as above mentioned might result to fan loosening or
falling.
DIAGRAM 3
Safety Cable
Connector
Top Canopy
Coupling Cover
Screw x 2
Hex-head
Screw
Motor Coupling
STEP 3 (See Diagram 3)
1 ) Loosen 2 screws on the motor
coupling.
2 ) Insert the downrod through top canopy
and coupling cover.
3 ) Thread the safety cable through the
downrod.
4 ) Connect both connectors from the
downrod and fan motor.
5 ) Lock the downrod to the motor
coupling, tighten up with 2 hex-head
screws and fixings.
6 ) Tighten 2 screws on the motor
coupling.
7 ) Slide down the coupling cover until it
rest on top of the fan housing.
Screw (Loosen)
Downrod
Wobble-free
Assembly
2 Screws in the middle
(Tighten)
Hook
The 1st
Hex-head Screw
The 2nd
Hex-head Screw
Metal Washer
Pin
Metal Nut
Lock Washer
Fixings
