7
English
www.ruck.eu
2.5. Adhere to the following instructions
•
Observe the provisions for accident prevention and environmental protection for the country
where the product is used and at the workplace.
•
Persons who assemble, operate, disassemble or maintain
ruck
products must not consu-
me any alcohol, drugs or pharmaceuticals that may affect their ability to respond.
•
Responsibilities for the operation, maintenance and regulation of the product should be
clearly determined and observed so that there can be no unclear areas of responsibility with
regard to safety.
•
Never overload the product. Never use it as a handle or step. Do not place anything on it.
•
The warranty only applies to the delivered configuration.
•
The warranty will not apply if the product is incorrectly assembled or handled or not used as
intended.
2.5.1. General instructions
2.5.2. During installation
•
Disconnect all of the product‘s poles from the mains before installing the product or connec
-
ting or removing plugs. Make sure that the product cannot be switched back on again.
•
Lay cables and lines so that they cannot be damaged and no one can trip over them.
•
Before commissioning, make sure that all gaskets and seals in the plug-in connections are
correctly fitted and undamaged in order to prevent fluids and foreign matter getting into the
product.
•
Information signs must not be changed or removed.
•
Make sure that all electrical connections are either used or covered. Commission the pro-
duct only if it is installed completely.
•
The power switch must always be fully functional and easy accessible!
2.5.3. During commissioning
2.5.4. During operation
•
Only authorized personnel is allowed to operate the setting mechanisms of the components
or parts, under the provision that the system is used as intended.
•
In an emergency, or if there is a fault, or other irregularities, switch the equipment off and
make sure it cannot be switched back on again.
•
The technical data given on the rating plate must not be exceeded.
2.5.5. During cleaning
•
Never use solvents or aggressive detergents. Only clean the product using a slightly damp,
lint-free cloth. Only use water to do this and, if necessary, a mild detergent.
•
Do not use a high-pressure cleaner for cleaning.
•
After cleaning, make sure that the product is working correctly again.
2.5.6. During maintenance and repair
•
If operated correctly,
ruck
products only require a minimum amount of maintenance.
Please follow all of the instructions given in section 10 in this respect.
•
Make sure that no connections or components are loosened unless the device is discon-
nected from the mains. Make sure that the equipment cannot be switched back on again.
•
Individual components must not be interchanged. For example, the components intended
for one product may not be used for other products.
2.5.7. Disposal
•
Dispose of the product in accordance with the currently applicable national regulations in
your country.
Summary of Contents for ETA K 1200 V W
Page 59: ...59 English www ruck eu Notes ...
