9
10.
Position the rear hinge brackets against the long beams. Once in position, weld the rear hinge
brackets to the body long beams as shown in Figure 6.
11.
Slide each of the lifting shafts against the inside of the channel long beam. Weld the lifting shaft
to secure the shaft to the long beam as shown in Figure 7. With the shaft secured, slide the lock
collars against the hoist lifting tube and lock them by tightening the 3/8" set screw (refer to
Figures 4 and 7). Torque each set screw to 24 ft./lb.
12.
Install all grease fittings. For grease fitting locations, refer to Figures 8, 9 or 10 on page 10.
Torque each grease fitting to 70 in./lb. Lubricate all grease fittings upon installation.
IMPORTANT:
Hoist should be greased periodically or every time truck is greased.
13.
With the hoist and body completely installed, cycle the hoist several times to rid the hydraulic
circuit of air.
14.
Referring to Body Prop Manual #03 6034, install body prop.
WARNING:
Installing or operating this hoist without first understanding the proper installation and
operation procedures can lead to serious injury or death. Always read and understand fully
all installation and operation manuals before installing or operating this equipment.
Summary of Contents for 03 3018
Page 11: ...10 ...
