WARNINGS:
Warning:
Not installing or operating equipment correctly can cause component damage or an
accident which may cause injury or death. "
Always
" install and operate equipment in
accordance with manufacturer's instructions. Read and understand this manual fully
before proceeding.
Warning:
Welding, oxy-fuel cutting, or grinding sparks can cause fuel to ignite which in turn can
lead to injury or death. "
Always
" take adequate steps to avoid ignition of fuel from fuel
tanks when welding, grinding, or oxy-fuel cutting during equipment installation.
Warning:
Heat from the truck's exhaust system can cause hydraulic component failure and may lead
to a fire which could cause injury or death. "
Always
" install equipment in locations where
heat from the exhaust system will not damage any hydraulic component.
Warning:
Being under a raised body can result in serious injury or death should the body
inadvertently descend. "
Never
" position yourself or allow others to position themselves
under a "
loaded
" body. "
Always
" prop the "
unloaded
" body up using the body prop or
body props supplied. "
Remember
" body props are to be used only on an "
unloaded
"
body.
Warning:
Malfunctioning equipment can cause property damage, injury or death. "
Always
" have
faulty equipment repaired before continuing its use. If required, consult the manufacturer.
Warning:
Overloading of a truck can cause truck component damage or an accident which may
cause injury or death. "
Never
" exceed the gross vehicle weight (GVW) or the gross axle
weight (GAW) rating of your vehicle.
Warning:
The inadvertent shorting of the truck's electrical supply can cause a fire or equipment
damage that could lead to injury or death. "
Always
" disconnect the vehicle battery prior
to installing, servicing or repairing the pump.
Warning:
Never install a cable on a truck while the body is raised without first blocking, bracing, or
propping the body up to prevent the body from inadvertently falling when the control
valve lever is moved. A falling body will result in serious injury or death if the control
valve lever is moved while someone is under the non-supported body.
Warning:
Damage to brake lines during equipment installation, or installing bolts or equipment in
such a way that the line will rub and become damaged can lead to brake failure which can
cause an accident and can lead to severe injury or death.
"Always"
take adequate
steps to prevent brake line damage during installation and isolate brake lines from
installed equipment.
3
Summary of Contents for 03 3018
Page 11: ...10 ...
