Customer Operation and Safety Guide
Rug Doctor Support: 1-800-784-3628 |
Page 1 of 3
Machine/Tool ID:
DSC-1R & DSC-2R Pro Portable Detailer and Spot Cleaner
Vendor:
Rug Doctor
Vendor Website:
Mfg. Support Phone No.:
1-800-784-3628
Tool Application:
Detailer and portable spot cleaner. Great for cleaning most auto interiors, stairs, rugs, upholstery,
carpet, mattresses, and pet beds. Always use Rug Doctor cleaning solutions.
Operation Guide: Read all instructions completely before you begin.
USER MUST READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE USING THIS MACHINE.
Before operating this machine
(including any attachments), renter agrees to fully read, understand, and follow all safety warnings and instructions set forth
below,
which can be found on Rug Doctor’s website (www.rugdoctor.com).
USING THE MACHINE
1
Locate the Clean Water Tank: It is the tank located on the left of the machine and is labeled Clean Water Tank.
2
Push the Clean Water Tank Release Button and pull the tank in an outward motion to release tank.
3
Unscrew the Easy Measure Solution Pour Cap from the Clean Water Tank. Fill the Clean Water Tank with HOT tap water until it
reaches the fill line.
4
Follow the directions on the back of the Rug Doctor cleaning solution and fill the Easy Measure Solution Pour Cap with the
recommended ounces of solution. Clean Water Tank holds .75 gallons of water.
5
Tightly screw the Easy Measure Solution Pour Cap onto the tank. Securely place the full Clean Water Tank back onto the
machine.
You will hear a “Click” sound
when the tank has locked into place.
6
The Motorized Upholstery Tool is easily lifted from the machine front while the Tool Handle is easily slid out from the Tool
Handle Holster on the back. Unwrap the Hose from the Tool Hose Wrap on the back of the machine.
7
Once separate from the machine, connect the Motorized Upholstery Tool and Tool Handle. Press the two pieces together
firmly to assure proper connection.
8
Plug in the machine to a properly grounded outlet. Turn on the machine: Press the Power Button
to “On” on the top of the
machine. The Tool Brush will spin when power is turned on.
9
To start cleaning, squeeze and hold the Cleaning Solution Trigger while slowly moving the tool back and forth over the stain,
releasing the Cleaning Solution Trigger when complete. Excess solution can be removed by making additional passes with the
tool without squeezing the Cleaning Solution Trigger. This may permit faster drying.
10
Emptying Dirty Water Tank: Locate the tank on the right of the machine. Push the Dirty Water Tank Release Button and pull
the tank in an outward motion to release tank.
11
Remove Dirty Water: Unscrew the Wide Opening Lid on the back of the tank, remove the Dirt Water Tank Float and pour out
the dirty water. (Dirty water should be poured into toilet or outside.)
12
Rinse out the Dirty Water Tank with warm water and screw lid back on tank. Securely place the Dirty Water Tank back onto
the machine. You will hear a click sound when the tank has locked into place. Continue cleaning until finished.
13
When cleaning is complete:
Leave the machine running for 15 seconds
after cleaning to allow for all of the dirty solution to
be collected in the Dirty Water Tank. Then switch the machine OFF.
14
Clean and Rinse out both tanks with warm water, remove lint and hair from the tool brush roll, and wipe down the machine.
After rinsing and drying both tanks, replace tanks and lock in place.
15
Disconnect the Motorized Upholstery Tool Head from the Tool Handle and place into Motorized Upholstery Head Pocket on
front of machine.
