EN
6
Connect the USB cable with the USB port (5).
Then connect the cable with power adapter.
After charging, remove the USB cable from the charger.
INSTALLATION OF THE NANO SIM CARDS
The device has two slots for a nano SIM card. These are located on the back of the unit.
If you have installed two SIM cards, you can choose your primary card in:
<Settings> <SIM cards>
.
WARNING
Do not try to insert or remove the SIM cards when any external power supply
is connected, otherwise the SIM card may be damaged.
INSTALLATION OF THE microSD CARD
The device has another slot for a microSD card.
If the SD card is not recognized, a reboot must take place, this can be started by
holding down the ON/OFF key for approx. 15 sec.
If you want to remove the microSD card, make sure the card is not being used by the
device by selecting
<Settings>
<Memory>
<Remove SD card>
<OK>
.
WARNING
Do not try to insert or remove the microSD card when any external power supply is
connected, otherwise the microSD card may be damaged.
SETTING PASSWORD
In settings a passwort is required, use standard password
“1234”
.
IMPORTANT INFORMATION!
FACTORY RESET / ACTIVATE OEM MODE
If you have set up a Google Account, it is important to proceed with the following
steps before you make a factory reset. This ensures that all private data will be deleted
on the device:
Settings
About phone
tip seven times on Build number (to activate the deve-
loper mode)
back to Settings
Developer options
enable OEM unlocking
enable
back to Settings
Backup & reset
Factory data reset
If you do not enable the OEM unlocking, the device will always ask you to sign in with
the previously synced Google Account after the restart. In that case the device is
unusable for other user.
