Cutting Centre SR 2 Turbo
5
Start the machine. – Open knife protection box 20 mm
wide. – If the machine does not switched off, it must be
shut down immediately!
Start the machine. – Open the slider of the funnel 20 mm
wide. – If the machine does not switched off, it must be
shut down immediately!
Open the knife protection box. –Dismantle the transport
belt and upper belt section. – Close the knife protection
box. – Start the machine. – If it should start, it must be shut
down immediately!
!!! To shut down the machine, the emergency-stop switch must be
pushed to “Emergency-Stop”, the main switch turned to “0 – OFF” and
the power plug pulled from the outlet! The machine must be secured
against further use!
!!! The supervisor must arrange for the repair of the non-functional
safety device by a Rühle service technician. Until the corresponding
parts have been repaired, the supervisor must ensure that the ma-
chine or parts of the machine are under no circumstances put into op-
eration!
!!! The cleaning personnel must observe the work procedures from the
“Cleaning” work instructions prepared by the supervisor.
!!! The maintenance personnel may only carry out work specified as
“Regular care”, unless any other authorisation has been issued in
writing by the manufacturer of the machine. The maintenance per-
sonnel must observe the work procedures from the “Maintenance”
work instructions prepared by the supervisor.
The power plug must be disconnected for maintenance work!
!!! The machine may not be modified.
!!! Only Rühle spare parts and accessories may be used.
