21
The wing nut is fastened counterclockwise and loosened clockwise
so that the sectioning blade doesn’t turn loose during the cutting
process.
Now loosen the wing nut by a full turn and fasten the nut again
by swinging it round with lots of speed. This is sufficient to hold
the blade in position.
The plunger plate can be used to loosen the wing nut by giving the wing nut a slight push with
the plate in a clockwise direction.
3.6. The tool box
The storage area can hold 2 Multi-cutter frames, 6 Multiplex-
Cutter-halves, 5 stabilizers and 1 knife sharpener – this means good order,
safety and hygiene for all the accessories and the operator.
Should the machine be equipped with special plunger plates, then these
Items can be stored under the tool box.
The tool box is located directly at the rear side
of the machine.
After unlocking the hood of the tool box, it
can be moved up to 180° to the right hand
side by lifting it slightly.
A door latch keeps the door closed, so that
it can be opened with a soft pull and closed with
a soft push.
Only put clean, disinfected and dry accessories
into the tool box.
Apart from the accessories belonging to the
machine, no other parts are allowed to be stored
inside the tool box.
Open
Closed
Summary of Contents for SR1 turbo
Page 5: ...5...
