8
These values can vary, so take the values from
the data plate, positioned at the back of the
machine, before finally connecting the machine.
After an electrician has fitted a suitable power
plug to the power lead, the machine can be supplied
with power by connecting the lead to the power
point.
Turn the main switch from ”0” to ”1” to turn on
the machine.
Should it be impossible to start the machine
despite locking all safety devices, then the
rotang field has to be changed by an electrician
by changing over the two black leads inside
the power plug.
2.3 Commissioning of the machine
The operating manual has to be read and understood before commissioning the machine.
This is followed by cleaning and disinfecting of the machine according to the cleaning
instructions.
All accessories have to be checked for visible damage – a possible cause of the transport –
during the cleaning process. The same applies for the entire machine, especially the safety
devices
Switch ON the machine by turning the main
switch to „1“. Open the tool box.
Now clean and disinfect the entire tool box
according to the cleaning instruction.
Now clean and disinfect all HighTech-cutters and
hang them into the tool box.
Now the main switch has to be turned to ”0” so that the Rühle technician can
activate
the six
Self-lubricating
systems inside the machine.
After turning the machine on the main switch on again, the first test-run can be carried out,
by selecting the desired cutting program and inserting the relevant Multi-cutter into the machine.
Summary of Contents for SR1 turbo
Page 5: ...5...
