LaserCuttistV1.2 Laser Cutting system
RuiDa Technology E-Mail:
support@rd-acs.com
1TH FLOOR,5TH BUILDING,NANYOU
TIANAN INDUSTRIAL ZONE,SHENZHEN
Web:
www.rd-acs.com
Phone: (086)0755-26066687
FAX: 0755-2698287
26
Picture2-9 Close lines dialog
8 Delete overlapping lines
：
If there are two or more lines is too closed with each other, one of them is not useful. It can be deleted. The
interval length limit of two lines should be set. When lasercuttist check that the interval length of two lines is less
that the interval length limit, lasercuttist will delete the unuseful lines. Function is shown as picture 2-10.
Picture2-10 delete the overlapping lines
9
Merge
intersect
：
When some polygon lines of a closed curve are not connect with each other, the merge polygon lines
function can made the lines connect with each other. Before that, the merge error limit should be set. When the
length of two polygon lines is less that the merge error limit, the polygon line will connect with each other. When
the length of two polygon lines is more than the merge error limit, the merge polygon function will be
ignored.
Picture 2-11 Merge the polygon lines
10 Parallel line
：
This function will copy the single line in external direction and internal direction to generate two lines.
The start point and the end point of the two lines connect with each other to generate a
rectangle. Lasercuttist will
replace the single line with the rectangle to execute a cutting process.
