LaserCuttistV1.2 Laser Cutting system
RuiDa Technology E-Mail:
support@rd-acs.com
1TH FLOOR,5TH BUILDING,NANYOU
TIANAN INDUSTRIAL ZONE,SHENZHEN
Web:
www.rd-acs.com
Phone: (086)0755-26066687
FAX: 0755-2698287
36
Picture 2-21 Path optimization
If order of layer option is selected , Lasercuttist will optimize the path by layer after layer.
If inside to outside option is selected, you can select single inner to outer and single inner to
outer with find cut start point automatically.
If the block handle is selected, you should set the block height. After that, you can set the
direction of the optimization. Lasercuttist will follow the rules to optimize path.
When you select the start point optimization, lasercuttist will modify the cutting start point
to achieve a good cut result. The modified start point may not be polygon point. It may be a
new point on the curve.
When you select the auto determine cut start point and direction, the cut start point will be
modified according the
shortest path rule. The modified point is one of the polygon
points.
2 Sequence Manually
：
User can make the order of the curve elements manually. Shown as picture 2-22.
