LaserCuttistV1.2 Laser Cutting system
RuiDa Technology E-Mail:
support@rd-acs.com
1TH FLOOR,5TH BUILDING,NANYOU
TIANAN INDUSTRIAL ZONE,SHENZHEN
Web:
www.rd-acs.com
Phone: (086)0755-26066687
FAX: 0755-2698287
40
Picture 2-27 Adding bridge
You can set the bridge is all break or semi-break. If you select the all-break mode, laser will be off during the
bridge path. If you select half-break mode , laser will be on with half power during the bridge path.
The bridge width can be set too. The unit is mm.
There are 3 ways to generate the bridge. One is generating the bridge with interval length. Another is
generating the bridge with interval bridge quality. The other is generating bridge manually.
1)
Generate with interval length
：
When lasercuttist has been in the adding bridge status, you can generate bridges
on the curve with the interval length.
2)
Generate by number
：
When lasercuttist has been in the adding bridge status, you can generate bridge on the
curve by number.
3)
Generating bridge manually
：
When lasercuttist has been in the adding bridge status, you can click the left key to generate a bridge on the
curve.
8 Re_Locate
：
Relocate function is just for relocate the offset and rotation parameters of metal material. With these
parameters, lasercuttist can change the curve element coordination to achieve a correct result.
For example, the metal material has been cut for a quality of curve elements. But the metal material location
has been changed. So if you want to continue to cut the left curve element, you should use the relocating function.
9
Statistics
：
