LaserCuttistV1.2 Laser Cutting system
RuiDa Technology E-Mail:
support@rd-acs.com
1TH FLOOR,5TH BUILDING,NANYOU
TIANAN INDUSTRIAL ZONE,SHENZHEN
Web:
www.rd-acs.com
Phone: (086)0755-26066687
FAX: 0755-2698287
53
Picture3-4 Machine parameter
Direction polarity defines the running direction of motor X or Y. Home polarity and limit polarity should be set
correctly. If the home switch is normal open, the home polarity should be set negative. If the home switch is
normal close, the home polarity should be set positive. The same is to limit switches.
The parameters marked with red arc lines should be set properly. Especially for the “Origin pos”, it should be
set properly. The four points is according to the four corner of the machine. Once the home switch is installed, the
origin position is the same position with the home switch.
Notice
：
The origin position must be set correctly according to the home switch position.
The coordinate is including of absolute coordinate, current position. If you have execute a going home
operation, the coordinate is absolute coordinate.
When you import a data file, lasercuttist always display the file in the center of the valid cutting area. But
user can move, rotate the curves.
When start a cutting, how the laser head moves and cut the metal material? So there are 3
conception to
explain. As shown in picture 3-5.
