LaserCuttistV1.2 Laser Cutting system
RuiDa Technology E-Mail:
support@rd-acs.com
1TH FLOOR,5TH BUILDING,NANYOU
TIANAN INDUSTRIAL ZONE,SHENZHEN
Web:
www.rd-acs.com
Phone: (086)0755-26066687
FAX: 0755-2698287
54
Picture 3-5 Coordinate definition
(1) Absolute coordinate
：
When you select the absolute coordinate, lasercuttist will consider the machine home point as the
curve referenced point. That means the valid cut area is just the same to the machine platform. The
curve locates in the area is the same location in the machine platform. As shown in picture 3-6.
For example, cutting a rectangle, when absolute coordinate is selected, the laser head will jump
from the current point to the start point of the cut rectangle. Then , starts a cutting operation. When
finish cutting, the laser head will stay the end point. If you select the “run to stop point”, the laser head
will move to the stop point when finished the cutting.
Picture3-6 Laser head movement
(2) Current point coordinate
：
When “current point coordinate” is selected, lasercuttist will consider the current point as the
referenced point of the curves. The curve has 9 kinds of referenced points. As is shown in picture 3-8.
So the referenced points of curve have 9 kinds of relationship with the laser head. As is shown in picture
3-7. Picture just only list 4 kinds.
During cutting, blue dotted line means jumping, black line means cutting. The red array means
laser head. In the 9 kings work mode, the laser head location is not changed. Lasercuttist will change
the location of the curve.
Every data file has a default referenced point that displayed with green rectangle. The referenced point can be
changed by user. The change operation is in the “Parameter—system
Para”.
