LaserCuttistV1.2 Laser Cutting system
RuiDa Technology E-Mail:
support@rd-acs.com
1TH FLOOR,5TH BUILDING,NANYOU
TIANAN INDUSTRIAL ZONE,SHENZHEN
Web:
www.rd-acs.com
Phone: (086)0755-26066687
FAX: 0755-2698287
60
whole cut length, the whole jump length.
If you have select one or some curve elements, the information of the curve elements will be displayed.
The information is including of the number of selected curves, the whole work length, all the curves area,
the
coefficient of utilization. Shown as picture 3-16
Picture3-16 Statistical Information
The area and the
coefficient of utilization is relation with the attribute of the curves. So we must know the
sense of the inner mold and outer mold.
Seeing picture 3-17, The left curve is the imported data file. The right is the product after laser cutting. So in
order to get the correct result, we must set the inner mold and the outer mold of the curves correctly. If we set a
curve is inner mold, it means the outer part of the outline is useful. The inner part is rubbish. If we set a curve to
be an outer mold, the inner part of the curve outline is useful for us. The outer part of the curve outline is no useful.
So there is at least one outer mold in the curve elements.
See picture 3-17. We want to cut a butterfly. So before we start a cutting, we should set curve element 1 to 16
to be inner mold. Curve element 17 should be set to be outer mold.
Picture 3-17 Inner mold and outer mold
Imported data check
As to the imported data file, the file has some discrete error. We usually can not tolerate the error when we
cutting a product with high precision. So some check and revision must be done. Lasercuttist give some
tools to check and revise the data.
