LaserCuttistV1.2 Laser Cutting system
RuiDa Technology E-Mail:
support@rd-acs.com
1TH FLOOR,5TH BUILDING,NANYOU
TIANAN INDUSTRIAL ZONE,SHENZHEN
Web:
www.rd-acs.com
Phone: (086)0755-26066687
FAX: 0755-2698287
65
The accelerator used in the cutting. The cut velocity is located in the layer parameters.
Motion delay:
The delay that is inserted after the jump motion .
Frame blank
When the frame black is set, The actually going scale will enlarge the curve’s frame.
Going home velocity
Lasercuttist goes home with the velocity. The accelerator is decided by the jump
accelerator.
XY home offset
The offset between the home switch position and the real machine home.
（
2
）
Delay parameter
Penetrate delay
Laser head jumps to the start point of a curve. And then execute a penetrate operation
with laser on. In order to penetrate a hole on the metal material, the laser will be on for a
time. The time is the penetrate delay.
Tracing delay
The time that the laser head spend when running down to the metal material platform.
The time can not be set too small. If the time is too small, the laser head can not reach to
the metal material platform and start tracing status. If the time is too long, the efficiency
will be very low.
User can click the button on the lasercuttist to control the tracing head rising or
running down. The tracing delay can be measured through this way. As is shown in picture
3-21
Picture 3-21 Tracing control
Gas open delay
The time from the open the air valve to the laser on. The delay is just for gaining a stable
pressure. It is usually to be set less than 100ms.
Gas close delay
When finishing a cutting task, the laser will be off immediately. But we usually want the
air to blow for a time after laser off. The time is the gas close delay.
Rise delay
Rise time means the time that the tracing laser head rises from the metal material platform
