LaserCuttistV1.2 Laser Cutting system
RuiDa Technology E-Mail:
support@rd-acs.com
1TH FLOOR,5TH BUILDING,NANYOU
TIANAN INDUSTRIAL ZONE,SHENZHEN
Web:
www.rd-acs.com
Phone: (086)0755-26066687
FAX: 0755-2698287
69
Picture3-25 Adding introducing line automatically
If you want to add a introducing line to the curve, the introducing line is added on the start point of
the curve. If the curve is set to be inner mold, the finally result is shown in picture 3-26.
Picture3-26 Add the introducing line of inner mold
After adding the introducing lines, lasercuttist is in the introducing line edit status. A cross on the
cursor is displayed. Now you can modify the introducing line. There is a small rectangle on the
introducing pin-in line. There is a small green rectangle on the introducing pin-out line. User can
press down the left key and drag the blue or green rectangle to modify the introducing pin-in-out
line.
If you want escape the introducing line edit status, please press the right key of the mouse.
Manual
Click “handle—add introducing line”, The dialog appears as shown in picture 3-27.
In the manual mode, the introducing pin-in line and the introducing pin-out line can be added
independent
.
