RDLC320 Controller User Manual
38 / 45
© 2016 Ruida Technology. All Rights Reserved.
Acceleration Mode
: it is divided into T acceleration and S acceleration. T accelerate will quicken
the whole cutting process, but it will result in that its cutting effect is inferior to that of S
acceleration.
(2) Sweep Parameters (Only affect scanning mode)
X Start Speed
Y Start Speed
X Acceleration
Y Acceleration
The above four parameters are used to set the starting speed and acceleration of two axes when
scanning. The higher the two speeds are, the quicker the scanning is.
Line Shift Speed
: this parameter is specially used to control the highest speed at which the
previous line moves to the next line vertically in the scanning mode. If the line space is larger
during the scanning or if the distance of each block is larger during scanning block graphics, it is
necessary to position each line or block accurately. In such a case, the line shift speed can be set as
a lower value.
Scan Mode
: it is divided into general mode and special mode. If in special mode, the laser power
should be increased. The smaller the spot percentage is, the more the laser power reduces. The
laser power should be set larger to reach the same scanning depth. The purpose to select the
special mode is to emit laser light at high power in short time, to get the flatter bottom on depth
scanning, but it should be notice that if the spot size adjustment is not appropriate, it might not
achieve this goal. And the high power emitting in short time mode will influence the laser life. The
system defaults as general mode.
Facula/Spot Size
: When selected the general mode as scanning mode, this parameter is invalid;
when selected the special mode, this parameter is valid. The controller will control this parameter
among 50%~99%.
The cutting and scanning parameters can’t exceed the limited ones in the axis
parameters. If so, the setting will become ineffective and the system will
automatically cover the parameters with the axis parameters.
(3) Reset Parameters
Reset Speed
: it means the speed of X/Y-axis linkage reset to the origin.
Prompt
