10
you have unhanded it! Then fasten all six screws with 25 Nm. After that, please check again if
the blades shifted because of tighten the screws. A small unbalance can be cleared with the
mounting of the spinner. After all screws are tightened, locking varnish has to get smeared
over the screws.
Mount the spinner into the counting plate with a 45mm long screw, do not fasten the screw
too tightly. Now only the vane is missing.
The tail is not only able to turn the wind turbine into the wind automatically, but also to
protect the Black 600 of overload. The tail turns slowly out of the wind when the wind speed
is too high at about 550 Watt. Therefore it is important that the tail is mounted correctly. The
tail has always be able to dissemble itself laterally. The screw, which holds the tail, may not
clamp the tail. During mounting please take care that you fill in much grease into the space
where the pen will be placed in, so that there is always a certain movability.
The dashed line shows the position at too
high wind speeds
The wind generator produces a three-phase alternating current, it makes sense to convert to
continous current with the charge controller, but not until it is short of the battery. The reason