15
discharged at a 24 volt system, it can happen that the charge controller will recognize a 12
Volt system.
You can see the voltage V and the current I, which lies against the battery.
Charge off: push the and – , program the charging end voltage of your batteries, pay
attention to the descriptions of your battery’s company, the charging end voltage can be
between 12 and 15 Volts.
Charge shows you, how much ampere hours were charged into the battery. This value is used
as a relation value, because every 10 seconds information of the charge controller get
requested.
It is the same as above, just in kWh.
Shows you the capacity in Watt, which is produced at the moment.
You can also define and connect consumer load to the charge controller, when the consumer
load should switch off or on. The consumer load is called User and is measured in ampere
hours.
Push the + and – buttons to adjust at which voltage the charge controller will switch off the
consumer load.
