RG-S7800C Switch Quick Installation Guide, V1.2
Installing the Switch
18
If a slot is not inserted with a supervisor module, or service module, please cover the slot with a filler panel for heat dissipation.
(3) Module Installation on RG-S7805C
1)
Pull out both levers (
①
in figure 4-20
).
2)
Insert the module into the slot along the rail and drive it ahead smoothly (
②
in figure 4-20
).
3)
Push both levers toward the slot (
③
in figure 4-20
).
4)
Tighten captive screws on both sides of the panel (
④
in figure 4-20
).
Figure 4-20 RG-S7805C in Chassis
4.11 Connecting the Power Cord
Connect the power cord to the location as required according to the identification on the power module panel, including
RG-PA1600I-F,
RG-PA600I-F, PA300I-F, PA460I-F
,
RG-PA3000I-PL and RG-PA1600I-PL
.
Make sure the socket is powered off before the power cord is connected.
1) Insert the AC power plug into the power module socket.
2) Take out the spring clip.
3) Install the spring clip on the front panel of the power module.
4) Fasten the spring clip to the power cord.
5) Connect the other end of the power cord to an external power socket.
Figure 4-21 Connecting Power Cord on RG-S7808C
