RunCam RunCam 3, User Manual

FCC Statement 

This equipment has been tested and found to comply with the limits for a 
Class B digital device, pursuant to part 15 of the FCC rules. These limits 
are designed to provide reasonable protection against harmful interference 
in a residential installation. This equipment generates, uses and can radiate 
radio frequency energy and, if not installed and used in accordance with 
the instructions, may cause harmful interference to radio 
communications. However, there is no guarantee that interference will not 
occur in a particular installation. If this equipment does cause harmful 
interference to radio or television reception, which can be determined by 
turning the equipment off and on, the user is encouraged to try to correct 
the interference by one or more of the following measures: 
‐Reorient or relocate the receiving antenna. 
‐Increase the separation between the equipment and receiver. 
‐Connect the equipment into an outlet on a circuit different from that to 
which the receiver is connected. 
‐Consult the dealer or an experienced radio/TV technician for help. 
To assure continued compliance, any changes or modifications not 
expressly approved by the party. 
Responsible for compliance could void the user’s authority to operate 
this equipment. (Example‐ use only shielded interface cables when 
connecting to computer or peripheral devices). 
This equipment complies with Part 15 of the FCC Rules. Operation is 
subject to 
the following two conditions: 
(1) This device may not cause harmful interference, and 
(2) This device must accept any interference received, including 
interference that may cause undesired operation. 
RF warning statement: 
The device has been evaluated to meet general RF exposure requirement. 
The device can be used in portable exposure condition without restriction.