Installation
LightStyle™ LS-12d Installation/Operation Manual
31
PRE
L
IMINAR
Y
1.
Position the flat side of the motorized transport against the bottom side of the
Attachment Plate so that the center “M” hole in the Attachment Plate is aligned with
the front recessed transport hole.
2.
Insert the #10-32 pivot screw up through the transport and Attachment Plate and
loosely complete the assembly with the corresponding washer, lock washer and nut.
3.
Loosely insert the four small 3/8” screws through the four remaining “M” slots through
the top of the Attachment Plate and down into the transport.
4.
Separate the Anamorphic Lens and lens bracket. Locate the lens bracket mounting
screws and use them to attach the bracket to the transport assembly. Observe the
sticker on the plate showing the correct sequence for installing and tightening the
screws.
Install Transport Pivot Screw Here
S
crew, Phillip
s
PH,
#6-32 x 3/8" (4)
Loc
k
Wa
s
her, #10-32 (1)
Flat Wa
s
her, #10-32 (1)
Nut, #10-32 (1)
Pivot
S
crew, Phillip
s
PH,
#10-32 x 5/8" (1)
Transport Assembly
Transport Assembly
Attachment Points
Attachment
Plate
Pivot Screw,
as assembled
Hardware for Lens Transport Assembly:
Summary of Contents for LightStyle LS-12d
