STRONGEST CABLE PULLING
WWW.RUNPOTEC.COM
RUNPOTEC GmbH – Irlachstrasse 31 – A-5303 Thalgau
Tel.: +43-6235-20 335 – Fax: DW 35 – office@runpotec.com
ENGLISH
13
USE OF ACCESSORIES SYSTEM CASE MOUNTING PLATE
USING THE GUIDE JAWS
GUIDE FOR A MEASUREMENT
2
1
1
2
3
4
Select guide jaws for the respective cable diameter according to the table be-
low. Insert in pairs, with the selected diameter facing up, into the holes provided.
See page 4 – 5 for further application examples
Cable cross-section
Guide jaws
Ø 2 – 6 mm
Ø 6 mm – red
Ø 7 – 12 mm
Ø 12 mm – grey
Ø 13 – 18 mm
Ø 18 mm – grey
Ø 19 – 24 mm
Ø 24 mm – red
Ø 25 – 32 mm
Without guide jaws
5
x
x
Open the lid of the RUNPOMETER with the
1
locking button on the side. Select
and install the guide jaws
2
(see Using the guide jaws). Insert the cable to be
measured and close the instrument lid. Align cable start flush with front housing
surface.
Note the index mark (arrow)!
5
Reset the measured value to 0 (hold RES button
D
down for 3 seconds).
Pull the cable slowly and evenly by hand to the desired length/length to
be measured. Read off the measured value/cut the cable, the front housing
surface is the index mark
Index mark
5
– Arrow marks front housing surface of the device as measuring
reference (start/end point for measurement).
The RUNPOMETER RM35 can be attached to the RUNPOTEC system case for
stationary operation by means of a mounting plate.
1 Open the folded system case mounting plate by pressing the red button.
2 Place on case, engage to case on one side.
3 Fix the system case mounting plate on the other side with the red case
locking mechanism. (Fold the red locking mechanism up).
4 Insert/engage the device into/in the holder provided for this purpose.
To remove the device: press the red button, remove the device.
