38
Press the MODE button to accept the changes and return to
the previous menu.
Activate/Deactivate Training Zone Alarms
When you aren't looking at your watch, you can be alerted when
you are above or below your set heart rate zone.
To hear an audible alert when your heart rate is outside the training
zone:
Select SETTINGS from the menu
HRM
HR ZONE
ALERT
Use the ST/STP or Lap/RESET buttons to choose "On"
(activated) or "Off" (deactivated)
Press the MODE button to accept the changes and return to
the previous menu.
Note: The alarm for the training zone only works in training mode.
Pairing a chest strap with the GPS watch
Each chest strap has its own ID and was paired at the factory with
the GPS watch. If you replace the GPS watch or the chest strap,
they must be paired again.
Select SETTINGS from the menu
HRM
PAIRING
Touch the watch to the contact surface of the sensors and
hold it there for a few seconds.
"Pairing Chest Strap" will be displayed on the watch.
If pairing was successfully performed, the notification "DONE!"
appears on the watch.
If the notification "FAIL" appears, then the pairing did not work.
Try again, repeating the steps above
After pairing, switch “HRM” back to “On” see section ###
Summary of Contents for GPS Watch with Heart Rate Measurement
Page 1: ...GPS Watch with Heart Rate Measurement Operating instructions Edition 04 2013...
Page 5: ...5...
Page 70: ...70...
