Page
10
of
12
Once the softener is programmed you can now start passing water through the
unit
•
Fill the Cabinet brine tank with water approx. 25mm above the salt
platform
•
Add at least two bags of salt to the platform
•
Put the softener into Regeneration
–
screen will display -00- this is the
valve moving into the backwash cycle, once this has stopped the
backwash symbol will be displayed and the minutes will start
counting down.
•
Slowly open the inlet water connection a ¼ turn to allow a small flow of
water into the softener to releasing air out of the cylinder
•
Once all the air has been removed from the cylinder you can now open
the inlet valve fully to clean the resin bed
•
When the water is running clear press the regen button again to skip to
the next cycle
•
The valve will now be in Brine draw cycle, press the regen button again
to skip to brine refill
•
Allow the valve to top up the brine tank to the required level for a salt
solution
•
Once refill has completed leave the valve to complete the regeneration
process and rinse the resin bed
