8
TYPE
PROTECTION CLASS
OPERATING VOLTAGE
ABSORBED CURRENT
ABSORBED POWER
ORBITAL DIAMETER mm
ORBITAL RPM
ELECTRONIC SPEED CONTROL
TURBINE
PLATE RUBBER DRILLED VELCROED
PLATE RUBBER DRILLED
PLATE DIMENSIONS mm
EXTRACTION SYSTEM
WEIGHT Kg
SSPF
II
230 V - 50 Hz
1,7 A
350 W
5
6.000
NO
NO
YES
YES
115x 208
YES
3,6
SSCA
II
230 V - 50 Hz
1,7 A
350 W
5
6.000
NO
YES
YES
YES
115x 208
YES
3,6
SO31TE
II
230 V - 50 Hz
1,2 A
380 W
3
8.500
YES
NO
YES
YES
115x 208
YES
2,75
TECHNICAL DATA
ENGLISH
8
SAFETY AND ACCIDENT PREVENTION INSTRUCTIONS
The safety and accident prevention instructions are reported in the
“SAFETY INSTRUCTION” booklet which forms an integral part of
these documents; the operating instructions indicate the additional
information required specifically for use of the tool.
Never use the tools without the safety guards.
Any operations carried out on the tool must be effected with the power
supply disconnected.
Before starting the tool, ensure that it is held tightly and not in contact
with the work surface.
Wear clothing suited to the work you are about to perform.
The electric tool must be connect to a suitable dust extraction unit
(not supplied): use regulation safety devices for personal protection
and observe safety norms valid for the processed work material.
Due to risks that may arise during polishing, we recommend the con-
stant use of P.S.D. (personal safety devices such as gloves, headpho-
nes, goggles, face masks, etc.) according to laws in force to prevent
or reduce accident probability.
Warning!
the appliance continues to work for a few seconds after it
has been switched off!
CORRECT USAGE
The sanders are designed for sanding wood, plastic, composite
materials, paint/varnish, filling material and similar materials.
Metal and materials with an asbestos content must not be processed
with these tools.
The machine must not be operated in humid environments or in the
presence of flammable gas or liquids.
Make sure the work piece is sufficiently fastened.
In the event of improper use, the user is fully liable for any damages or
accidents.
GENERAL WARNINGS
The tool must be connected to a suitable dust extraction system (not supplied).
Summary of Contents for SO31TE
Page 32: ......
