© All rights reserved to
Ruptela UAB
P a g e
|
42
Fig. 5.2.3.8. Driver installation
5.3. CONFIGURATOR
In order to use configurator go to folder where you saved configuration software and launch
„VCP.exe“ file. This configurator is intended to configure FM-Eco3, FM-Pro3 and FM-Tco3 devices.
5.3.1.INTERFACING TO COM PORT
In the main view upper left corner there is a drop box which contains COM ports list. You should
select port corresponding to your device (you can check it in “Device manager”) and click
“Connect” button. If connection is successful, “Connect” button changes into “Disconnect” and in
the bottom of the main view there should be information available about software, hardware and
IMEI number (Fig. 5.3.1.2.). Also while connected, the device type will be detected (Fig. 5.3.1.3.)
Fig. 5.3.1.1 COM port drop-box
FM
Manual
Summary of Contents for ECO3
Page 11: ... All rights reserved to Ruptela UAB P a g e 11 2 6 FM PRO 3 DIMENSIONS FM Pro3 ...
Page 21: ... All rights reserved to Ruptela UAB P a g e 21 3 6 FM ECO3 DIMENSIONS FM Eco3 ...
Page 29: ... All rights reserved to Ruptela UAB P a g e 29 4 6 FM TCO3 DIMENSIONS FM Tco3 ...
Page 48: ... All rights reserved to Ruptela UAB P a g e 48 Fig 5 3 3 2 Timetable view FM Manual ...
