2. Configurator
In order to use configurator go to folder where you saved configuration software and
launch „VCP.exe“ file. This configurator is intended to configure FM-Eco3, FM-Pro3 and FM-Tco3
devices.
2.1 Interfacing to COM port
In the main view upper left corner there is a drop box which contains COM ports list. You
should select port corresponding to your device (you can check it in “Device manager”) and click
“Connect” button. If connection is successful, “Connect” button changes into “Disconnect” and on
the main view bottom there should be information available about software, hardware and IMEI
number (Fig. 2.1.2). Also when connected device type will be detected (Fig. 2.1.3)
In order to disconnect click “Disconnect” button. Sometimes when connected IMEI is
displayed as few unconditional characters, this means that device is not fully ready. Try to
disconnect, wait for a half minute or longer and connect again – this should fix the problem.
Fig. 2.1.1 COM port drop-box.
Fig. 2.1.2 Changes after connection to COM port
Fig. 2.1.3 Device type selection drop-box
