For a terminal connected via a Wiegand interface, no further configuration is required.
If the terminal is connected via the RS-232 interface, it is necessary to make additional
settings for the Access level:
1. Go to the ACS (Access Control System) configuration, Schedules. Draw up a custom
schedule such as Pass 0-24 (Fig. 9).
2. Go to the Access levels section. Create a new access level and open the Add Access
Point dialog. Select the drawn up Pass schedule and enable the Multi-Factor Authentication
option.
3. For the Card or Face mode, add By face (controller) to the Identification section (Fig. 10).
For the Card and Face mode, add By face to the Controller section (Fig. 11).
4. Save the access point settings.
5. Assign the created Access Level to Employees or Employee Groups.
Fig. 8. Checking the terminal connection to the system
Fig. 9. Drawing up a custom schedule
