6
switching off
50 The hotplate will keep the carafe warm for up to 3 hours 59 minutes.
51 After this “keep warm” period, the coffee maker will switch itself off.
52 If left for much more than an hour, chemical changes in the coffee liquor start to affect the
flavour. It’s best to pour it away and make a fresh pot.
53 To interrupt the brewing process, or terminate the “keep warm” period manually, press and
release the
[
button.
54 The
[
light will go out.
55 Let the coffee maker and carafe cool down fully before cleaning, or for about 10 minutes
before refilling.
caution
Raising the lid before the coffee maker has cooled down may release steam, creating
a scald hazard.
a quick cup
56 If you want a quick cup of coffee before the brewing cycle has finished:
57 You can remove the carafe at any time. The non-drip valve will prevent coffee dripping on to
the hotplate.
58 To prevent the filter holder overflowing, replace the carafe on the hotplate within about 20
seconds. This may not sound much, but you’ll find it’s more than enough time to pour a
couple of cups of coffee.
59 When you replace the carafe on the hotplate, the non-drip valve opens, to let any remaining
coffee through.
1-4 function
60 If you’ve filled the reservoir, but you only want 4 cups, press and release the 1-4 button
before starting to brew.
61 The coffee maker will brew only 4 cups, then stop, and the “keep warm” function won’t be
activated.
“keep warm” time
62 The default “keep warm” time is 2 hours. You may change this to a maximum of 3 hours and
59 minutes. It’s quite complex, so we suggest you leave it at the default time.
63 Put 2 cups of water into the reservoir.
64 Put the carafe on the hotplate, as water will run through the coffee maker while you’re
setting the keep warm time.
65 Set the time (point 43 on page 5), otherwise the display will flash while you’re working.
66 If the
Y
light is out, press and release the
Y
button till the
Y
light glows.
a) press and release the
Z
button till a dot shows on the display above
9
b) press and release the
Z
button again – the display will revert to normal time
c) press and release the
[
button – the
[
light will glow, and water will start to come
through the coffee maker
d) press and release the
Z
button 3 times, till a dot shows on the display above
9
e) press and release the
h
button till the correct number of hours is shown – the hours
display changes in the sequence 2 - 1 - 0 - 3 - 2 (it counts down from 3)
f) press and release the
min
button till the correct number of minutes is shown – the
minutes display changes from 00 to 59, then counts down
g) press and release the
Z
button, to return to the “normal” display
h) press and release the
[
button – the
[
light will go out, and water will gradually stop
coming through the coffee maker
i) let the coffee maker cool down for 10 minutes, then use it normally
j) the coffee maker will retain the “keep warm” time you set, as long as you don’t unplug it
Summary of Contents for 14752
Page 1: ...instructions ...
Page 2: ...2 ...
