ELECTRONIC SPEED CONTROL
The polisher electronic speed control supply the following
fea-tures.
Speed setting
The speed of the polisher can be set by rotating the speed
dial(3) to the desired setting for any speed between 4000 and
5500r.p.m.
Speed compensation
In case of overloading the polisher, the electronic speed
controlwill compensate and maintain the selected speed till a
safe level. Exceeding this overload level may result in strong
vibrations andtool overtemperature.
Starting acceleration ramp
To avoid kickback effect and compound splattering, the
electronic speed control always supply a smooth starting
acceleration ramp when the tool is turned on.
OPERATION
INTENDED USE
The LHR12E and LHR75E heavy-duty polishers are designed-
for polishing painted or unfinished surfaces, fiberglass, and
com-posite in professional applications. Common examplesof
use include but are not limited to: auto/marine/RV/motor
cycledetailing and finish correction, boat construction and
surface finishing. Do not use in the presence of flammable
liquids or gases. Do not let children come into contact with the
tool.
Supervisionis required when inexperienced operators use this
tool.
MOTOR
Be sure your power supply agrees with the voltage marked
onthe nameplate. 120 Volts AC 60Hz means alternating
currentonly. Voltage decrease of more than 10% will cause loss
of power and overheating.
PARTS OF THE TOOL
1 - Identification plate
2 - ON/OFF switch
3 - Electronic speed control
4 - Back-up pad fixing screw
5 - Handle
6 - Polishing mop (not supplied)
7 - Handle fixing screws
8 - Velcro faced back-up pad
9 - Motor ventilation slots
10 - Back-up pad Allen wrench
ON/OFF SWITCH
To turn the polisher on, push the lever of the switch (2) to
wardsthe body of the tool. To turn polisher off push back and
releasethe lever of the switch.
WARNING: To reduce the risk of injury, make sure the
polisher is not resting on the workpiece when the switch
is turned on.
WARNING: To reduce the risk of injury, turn unit off and
disconnect it from power source before installing and
removing accessories, before adjusting or when ma-
king repairs. Be sure the switch is in the “OFF” position.
An accidental start-up can cause injury
WARNING: Never modify any parts of the power tool.
Damage or personal injury could result.
MODEL
LHR12E
LHR75E
Ø POLISHING FOAM mm
130-150
80-100
Ø BACKING PAD mm
125
75
Ø ORBIT mm
12
12
POWER W
400
400
R.P.M.
4000 ÷5500
4000 ÷5500
WEIGHT kg
2,3
2
SPEED CONTROL
•
•
PROTECTION CLASS
II
II
OPERATING VOLTAGE
120 V AC - 60 Hz
120 V AC - 60 Hz
ABSORBED CURRENT
3,5 A
3,5 A
TECHNICAL DATA
ENGLISH
LHR12E
LHR75E
