•
Once the appliance has settled, locate the thermostat dial on the product and
set to “
-20" position and switch on the power. The compressor will begin to
work. Close the door.
•
You may hear faint gurgling or bubbling sounds when the refrigerant is pumped
to the cooling system and through the coils or tubing at the rear of the
appliance. When the compressor is in operation you may hear a slight whirring
sound or pulsating noise. The thermostat controls the operation of the
compressor, and you may hear a slight click as it cycles in and out (this is
normal).
•
To save energy, you should minimize the frequency and duration of door
opening.
Vacuum Balancer Fitment Instructions (Optional)
•
After closing the doors, a vacuum seal may form that will prevent re-opening of
the doors for around 1 minute. To prevent this, we have included an optional
Vacuum Balancer with your appliance.
•
The Vacuum Balancer is a small piece of plastic applied to the bottom of the
freezer by removing the tape attached, and sticking to the lower part of the
freezer as shown below.
- 8 -
Note: The Vacuum
balancer should be
positioned a minimum of
60mm, to a maximum of
100mm from the outside
of the appliance/
