cOOL SpRaY MIST
NOTE: Water spotting affects some fabrics. Test this out on a hidden part of the fabric first. The
cool spray mist works with dry or steam ironing, as long as there is water in the tank.
•
Check that there is water in the tank.
•
Lift the iron off the fabric.
•
Aim the cool spray mist nozzle at the fabric.
•
Press the
cool spray mist
button – you may have to
press it 2 or 3 times to pump water through the system.
BURST OF STEaM
Burst of steam works with both dry and steam ironing, as long as there is water in the tank,
and the temperature control dial is set above silk/wool.
•
Check that there is water in the tank.
•
Check that the temperature control dial is set above
silk/wool
.
•
Wait until the green Temperature Ready light illuminates.
•
Press the
burst of steam
button – you may have to
press it 2 or 3 times to pump water through the system.
•
Leave 3 seconds between bursts, to allow the iron
temperature to recover.
DRY IRONING
If you are going to be dry ironing only, there is no need to fill the water tank.
•
Move the steam control to
no steam
.
•
Set the temperature control dial to the desired setting.
•
Wait until the green Temperature Ready light illuminates, then commence ironing.
MAX
TEMPERATURE
CONTROL DIAL
STEAM CONTROL
MAX
TEMPERATURE
CONTROL DIAL
STEAM CONTROL
